Sony AITE260 - AIT E260/S Tape Drive Operating Instructions Manual page 20

20
Part 2. Preparation
DIP Switch Positions
(for the AITe1040, AITe1040V, AITe520, AITe520V, AITe390, and
AITe390V Drives)
Default
ON
OFF
1 2 3
*
Emulation Mode
To enable Emulation Mode, set DIP switch 2 [Emulation Mode] to ON.
ON
OFF
1 2 3
*
Emulation Mode for the AITe1040/AITe1040V drives return the following
as the Product Identification field of the Inquiry command.
SDX-900V
*
Emulation Mode for the AITe520/AITe520V drives return the following as
the Product Identification field of the Inquiry command.
SDX-700C
*
Emulation Mode for the AITe390/AITe390V drives return the following as
the Product Identification field of the Inquiry command.
SDX-700C
Terminator Power
To enable terminator power, set DIP switch 5 [Terminator Power] to ON.
ON
OFF
1 2 3
4 5 6 7 8
4 5 6 7 8
4 5 6 7 8
1 DR (Disaster Recovery)
Mode (OFF)
2 Emulation Mode (OFF)
3 AIT Library Interface
Mode (ON)
4 Reserved (OFF)
5 Terminator Power (ON)
6 Periodic Cleaning Req
(OFF)
7 DC Control (1) (ON)
8 DC Control (2) (OFF)