Freecom NETWORK HARD DRIVE PRO User Manual page 54

Freecom Network Drive Pro
4.1.5 Start recovery procedure
GB
This procedure can reset and repair an Network Drive Pro to factory default settings if you
cannot access your Network Drive Pro anymore. Your user data will not be deleted!
4
To restore your settings, please proceed as follows:
a) Enable the Recovery mode by clicking 'Start the recovery procedure' in the Freecom
Network Storage Assistant.
b) Turn the Network Drive Pro off using 'Shutdown'.
c) Unplug the Network Drive Pro's AC power pack.
d) Use a pointed object to carefully press the 'Reset' button. It is located next to the AC
power slot on the back of the Network Drive Pro.
e) Keep the 'Reset' button pressed down and reattach the AC power supply.
f) Release the 'Reset' button after 5 seconds.
g) The LED on the PWR button lights up, indicating that the Recovery mode is enabled.
The device's LED flashes while the recovery process is taking place.
h) Once the LEDs stop flashing and the LED on the PWR button turns off, the recovery
process is complete. A message window appears on screen, telling you that the
recovery is finished.
i) Once it is complete, press OK in the Freecom Network Storage Assistant window.
54