Chamberlain 3275 Owner's Manual page 21

3275 manual
Hide thumbs Also See for 3275:
Table of Contents

Advertisement

INSTALLATION STEP 12
Connect Door Arm to Trolley
Follow instructions which apply to your door type as
illustrated below and on the following page.
SECTIONAL DOORS ONLY
• Make sure garage door is fully closed. Pull the
emergency release handle to disconnect the outer
trolley from the inner trolley. Slide the outer trolley
back (away from the door) about 2" (5 cm) as shown in
Figures 1, 2 and 3.
• Figure 1:
– Fasten straight door arm section to outer trolley
with the 5/16"x1" clevis pin. Secure the connection
with a ring fastener.
– Fasten curved section to the door bracket in the
same way, using the 5/16"x1-1/4" clevis pin.
IMPORTANT: The groove on the straight door arm MUST
face away from the curved door arm (Figure 4).
• Figure 2:
– Bring arm sections together. Find two pairs of holes
that line up and join sections. Select holes as far
apart as possible to increase door arm rigidity.
• Figure 3, Hole alignment alternative:
– If holes in curved arm are above holes in straight
arm, disconnect straight arm. Cut about 6" (15 cm)
from the solid end. Reconnect to trolley with cut
end down as shown.
– Bring arm sections together.
– Find two pairs of holes that line up and join with
bolts, lock washers and nuts.
• Pull the emergency release handle toward the opener at
a 45° angle so that the trolley release arm is horizontal.
Proceed to Adjustment Step 1, page 23. Trolley will
re-engage automatically when opener is operated.
HARDWARE SHOWN ACTUAL SIZE
Ring Fastener
Nut 5/16"-18
Clevis Pin
5/16"x1-1/4" (Door Bracket)
Clevis Pin
5/16"x1" (Trolley)
Lock Washer 5/16"
Hex Bolt
5/16"-18x7/8"
21
Outer Trolley
Ring
Fastener
Door
Bracket
Figure 1
Clevis Pin 5/16"x1-1/4"
Nuts
5/16"-18
Door Bracket
Figure 2
Nuts
5/16"-18
Figure 3
CORRECT
Straight
Door
Curved
Arm
Door
Arm
(Groove
facing out)
Figure 4
Inner Trolley
Straight
Door Arm
Curved Door Arm
Lock
Washers
5/16"
Bolts
5/16"-18x7/8"
Lock
Washers
5/16"
Bolts
5/16"-18x7/8"
Cut this end
INCORRECT
Straight
Door
Arm
Clevis Pin
5/16"x1"
Emergency
Release
Handle
Curved
Door
Arm

Advertisement

Table of Contents
loading

This manual is also suitable for:

Security+ 3275-267Security+ 3275

Table of Contents