Power Output - YORKVILLE AP6040 Owner's Manual

All values are in WATTS. Measurements were made at the 0.1% distortion point. Some
CONTINUOUS AVERAGE POWER measurements required line currents greater than 30 Amps. The
amplifier under test was plugged into an IDEAL POWER LINE consisting of a REGULATED 120 VAC
RMS 60 Hz pure sine wave. Ordinary AC "wall outlet" lines will always exhibit varying and
unpredictable amounts of sag. To produce objectively verifiable and accurate specifications these
unknown factors must be eliminated by using an ideal AC line. When using an ordinary electrical
outlet, it will usually be possible to get 3600 Watts when the
measurements use a 10mS burst at 1KHz with a 1/8 sec
represents the maximum possible sine wave output power.
2-Conductor Speakon Cables
4

POWER OUTPUT

Both Channels Driven
Load 1 KHz Cont.
(OHMS) Avg.
8 1200
4 2000
1 KHz Burst
2000
3600
AP6040 drives 4 ohms. The BURST
ond pause be ween t bursts. The 1KHz burst
SPEAKON™ PIN
CONFIGURATION
B
+
PIN 2
–
PIN 2
4-Conducter Speakon Cable
A
+
PIN 1
–
PIN 1