Table of Contents
Advertisement
operating your Breville microwave oven
BefoRe fIRSt uSe
Remove and safely discard any packaging
material and labels before using the Breville
Microwave Oven for the first time. Carefully
unpack the Breville Microwave Oven and keep
all the packing material until all the parts of the
Breville Microwave Oven have been found and
the appliance has been assembled.
To remove any dust that may have accumulated
during packing, wash the roller ring and glass
turntable tray in warm soapy water, rinse in
clean water then dry thoroughly. Wipe the
interior and exterior of the Breville Microwave
Oven with a soft, damp cloth then dry
thoroughly.
Installation
1.
Make sure that all the packing materials are
removed from the inside of the door.
2.
This microwave oven must be placed on a
flat, stable surface to hold its weight and
the heaviest food likely to be cooked in the
oven.
3.
Do not place the oven where heat, moisture
or high humidity are generated, or near
combustible materials.
4.
For correct operation, the oven must have
sufficient airflow. Allow 20cm of space
above the oven, 10cm at back and 5cm
WARNINg: CheCK the oveN foR ANy dAmAge, SuCh AS mISAlIgNed oR
BeNt dooR, dAmAged dooR SeAlS ANd SeAlINg SuRfACe, BRoKeN oR looSe
dooR hINgeS ANd lAtCheS ANd deNtS INSIde the CAvIty oR oN the dooR. If
theRe IS ANy dAmAge, do Not opeRAte the oveN ANd CoNtACt A BRevIlle
SeRvICe CeNtRe.
WARNINg: do Not ImmeRSe the mICRoWAve oveN, poWeR CoRd oR
plug IN WAteR oR ANy otheR lIquId.
BMO100_MICROWAVE_FA.indd 11
at both sides. Do not cover or block any
openings on the appliance. Do not remove
feet. This microwave oven must not be
placed in a cabinet
5.
Do not operate the oven without glass tray,
roller support, and shaft in their proper
positions.
6.
Make sure that the power supply cord is
undamaged and does not run under the
oven or over any hot or sharp surface.
7.
The power outlet must be readily accessible
so that the oven can be easily unplugged in
an emergency.
8.
Do not use the oven outdoors.
Assembling the glass turntable tray
1.
Place the Roller Ring into position in the
indented space in the oven cavity base.
2.
Insert the Glass Turntable Tray into position,
matching the indents on the base of the
Glass Turntable Tray with the indents in the
shaft located in the centre of the oven cavity
base.
11
3/12/08 10:14:52 AM
Hide quick links:
Advertisement
Table of Contents
