Hunter 20174 Owner's Manual And Installation Manual page 12

8 • Completing Your Installation With a Bowl Light Fixture (Continued)
8-5. To attach the light kit, connect the upper plug connector
from the heat shield assembly to the lower plug connector
in the light kit assembly.
Note: Both plug connectors are polarized and will only fit
together one way. Make sure the connectors are properly
aligned before connecting them. Incorrect connection
could cause improper operation and damage to the
product.
8-6. Align the keyholes in the light kit assembly with the two
preinstalled housing assembly screws and turn the light
kit assembly clockwise until the screws are resting in the
narrow end of the keyhole slots.
8-7. Tighten the prinstalled assembly screws and install the
third assembly screw.
8-8. Install B10 candelabra bulbs (60 Watt Maximum) into
the sockets.
8-9. Hold the glass bowl up with the holes in the glass bowl
aligned with the holes in the metal rods.
8-10. Install the decorative screws into the metal rods to secure
the glass bowl in place.
Steps 8-8 – 8-10
12
45007-01 • 06/11/09 • Hunter Fan Company
Heat Shield
Assembly
Light Kit
Assembly
Steps 8-5 – 8-7
Assembly Screw
Metal Rod
Light Bulbs
(B10
Candelabra-
Based,
60 Watt
Maximum)
Decorative
Screw
Glass Bowl
Keyhole Slots