Wiring The Fan - Hunter 20171 Owner's Manual And Installation Manual

Receiver
A
B
C
D
Step 6-3
B • Receiver Black: "AC LIVE IN"
• Ceiling Black
C • Receiver White: "AC NEUTRAL IN"
• Ceiling White
Step 6-4
D • Fan Yellow
• Receiver Yellow
E • Fan White
• Receiver White: "LIGHT NEUTRAL OUT"
F • Fan Pink
• Receiver Pink
G • Fan Grey
• Receiver Grey
H • Fan Black/White
• Receiver Black/White: "LIGHT LIVE OUT"
I • Fan Red
• Receiver Red
Step 6-6
A • Ground/Green
Steps 6-3 – 6-6
Large Wire
Connector
Small Wire
Connector
6 • Wiring the Fan
All wiring must be in accordance with national and local electrical
codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a
qualified electrician.
I
H
Wall switches are not included. Select an acceptable general-use switch in
accordance with national and local electrical codes.
6-1. Disconnect the power by turning off the circuit breakers to the outlet
box and associated wall switch location.
G
F
6-2. Place the receiver inside the canopy, making sure that the jumpers
and the oval shaped holes in the bottom of the receiver are facing
E
down toward the bottom of the canopy.
6-3. Using the large wire connectors, connect the fan and receiver to the
power wires as follows:
• Connect the white wire (NEUTRAL IN) from the receiver to the
white wire from the ceiling.
• Connect the black wire from the receiver to the black wire from
the ceiling.
6-4. To connect the wires, hold the bare metal leads together and place a
wire connector over them, then twist clockwise until tight. Using the
small wire connectors, connect the fan to the receiver as follows:
• Connect the yellow wire from the fan to the yellow wire from the
receiver.
• Connect the pink wire from the fan to the pink wire from the
receiver.
• Connect the grey wire from the fan to the grey wire from the
receiver.
• Connect the red wire from the fan to the red wire from the
receiver.
• Connect the black wire with a white stripe from the fan to the
black wire with a white stripe from the receiver.
• Connect the white wire from the fan to the white wire
(LIGHT OUT) from the receiver.
CAUTION: Be sure no bare wire or wire strands are visible after making
connections.
9
42683-01 • 09/11/09 • Hunter Fan Company