Acquiring Gps Signals; Changing The Fuses; Specifications - Kenwood KNA-G610 Installation Manual

Acquiring GPS Signals

The fi rst time you turn on the KNA-G610, you must wait while the system acquires satellite signals for the fi rst time. This process
could take up to several minutes. Ensure that your vehicle is outdoors in an open area, away from tall buildings and trees, for fastest
acquisition. After the system acquires satellites for the fi rst time, it will acquire satellites quickly each time thereafter.

Changing the Fuses

If you need to replace a fuse on the red or yellow wires, to prevent a short circuit, ensure that the wires are not touching. Then
replace the old fuse with a new 2 A fuse.
When replacing a fuse, use only a new fuse with the prescribed rating. Using a fuse with the wrong rating may cause damage to
your unit. To prevent short circuits, disconnect the wire harness before replacing a fuse.
Specifi cations
General
Operating Temperature: From -4°F to 158°F (-20°C to 70°C)
Storage Temperature: From -40°F to 185°F (-40°C to 85°C)
9.5 to 25 Vdc
Operating Voltage:
Current Consumption: 0.16 A typical at 13 Vdc (Max 1.0 A at 13 Vdc)
70 uA typical at 13 Vdc
ACC off Current:
(W
Dimensions:
0.4 lb. (186 g)
Weight:
Internal non-removable memory and optional removable SD card (City Navigator
Map Storage:
System/power, GPS antenna, SD card slot, Mini-B for optional FM traffi c receiver
Connectors:
Navigation
1,575.42 MHz
Frequency:
Acquisition Times*:
< 1 second
Warm:
< 38 seconds
Cold:
< 45 seconds
®
AutoLocate :
*On average for a stationary receiver with an open sky view
1/second, continuous
Update Rate:
GPS Accuracy:
Position: < 32.8 ft. (10 m), typical
Velocity: 1.97 in./sec (0.05 meter/sec) RMS
External GPS antenna requires metal surface 60
Antenna:
included metal plate. A larger metal mounting surface improves GPS reception.
× × × 1 / × 3 /
H D) 6 / 1 8 13 16
1 2
CAUTION
in. × ×
(165 28.5 97 mm)
×
60 mm (2.36
- 4 -
map data)
®
× 2.36 in.)
or larger, such as a car roof or the