Computer Setup-Advanced - Compaq dc7700 - Convertible Minitower PC Utility Manual

Table 5 Computer Setup—Power (continued)
Hardware Power
Management
Thermal
Computer Setup—Advanced
NOTE:
configuration.
Table 6 Computer Setup—Advanced (for advanced users)
Option
Power-On Options
10 Computer Setup (F10) Utility
SATA power management enables or disables SATA bus and/or device power management.
●
Fan idle mode—This bar graph controls the minimum permitted fan speed.
NOTE: This setting only changes the minimum fan speed. The fans are still automatically
controlled.
Support for specific Computer Setup options may vary depending on the hardware
Heading
Allows you to set:
●
POST mode (QuickBoot, FullBoot, or FullBoot every 1–30 days).
●
POST messages (enable/disable).
●
MEBx Setup Prompt (enable/disable or hidden/displayed). Enabling this feature displays the
text CTRL+P = MEBx during POST. Disabling this feature prevents the text from being
displayed. However, pressing
is used to configure manageability settings.
●
F9 prompt (enable/disable or hidden/displayed). Enabling this feature will display the text F9 =
Boot Menu during POST. Disabling this feature prevents the text from being displayed.
However, pressing
Storage > Boot Order for more information.
●
F10 prompt (enable/disable or hidden/displayed). Enabling this feature will display the text
F10 = Setup during POST. Disabling this feature prevents the text from being displayed.
However, pressing
●
F11 prompt (hidden/displayed). Setting this feature to displayed will display the text
F11 = Recovery during POST. Hiding this feature prevents the text from being displayed.
However, pressing
See Factory Recovery Boot Support for more information.
●
F12 prompt (enable/disable or hidden/displayed). Enabling this feature will display the text
F12 = Network during POST. Disabling this feature prevents the text from being displayed.
However, pressing
● Factory Recovery Boot Support (enable/disable). Enabling this feature will cause an additional
prompt, F11 = Recovery, to be displayed during POST on systems with HP Backup and
Recovery software installed and configured with a recovery partition on the boot hard drive.
Pressing F11 causes the system to boot to the recovery partition and launch HP Backup and
Recovery. The F11 = Recovery prompt can be hidden with the
option (see above).
●
Option ROM prompt (enable/disable) Enabling this feature will cause the system to display a
message before loading option ROMs. (This feature is supported on some models only.)
Ctrl+P still accesses the ME BIOS Extension Setup Utility, which
F9 will still access the Shortcut Boot [Order] Menu screen. See
F10 will still access the Setup screen.
F11 will still attempt to boot to the HP Backup and Recovery partition.
F12 will still force the system to attempt booting from the network.
F11 prompt (hidden/displayed)
ENWW