Enterprise Card (Optional); Integrated Dell Remote Access Controller 6 (Idrac6 Enterprise Card (Optional); Installing The Idrac6 Enterprise Card - Dell PowerEdge T610 Hardware Owner's Manual

3 Locate the USB connector on the internal USB module and insert the
USB memory key into the connector. See Figure 3-12.
4 Close the system. See "Closing the System."
5 Place the system upright and on its feet on a flat, stable surface.
6 Reattach any peripherals, then connect the system to the electrical outlet.
7 Turn on the system and attached peripherals.
Integrated Dell Remote Access Controller 6
(iDRAC6) Enterprise Card (Optional)
The optional iDRAC6 Enterprise card provides a set of advanced features for
managing the system remotely.

Installing the iDRAC6 Enterprise Card

1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet and peripherals.
2 Open the system. See "Opening the System."
3 Remove the expansion card stabilizer. See "Removing the Expansion Card
Stabilizer."
4 Remove the cooling shroud. See "Removing the Cooling Shroud."
5 Remove the plastic filler plug for the iDRAC6 Enterprise port from the
system back panel. See "Back-Panel Features and Indicators" for the port
location.
6 Remove the VFlash SD card (if installed) from the iDRAC6 Enterprise
card. See "VFlash Media (Optional)."
7 Install the iDRAC6 Enterprise card:
Angle the card so that the RJ-45 connector fits through the hole in the
a
chassis for the iDRAC6 Enterprise port. See Figure 1-4 for the hole
location.
Align the front edge of the card with the two front plastic retention
b
standoffs near the iDRAC6 connector on the system board. See
Figure 6-1 for the location of the connector.
Press the card down until it is fully seated. See Figure 3-13.
c
Installing System Components
103