Table of Contents
Advertisement
2.9 Re-connect Cables
You may have disconnected some cables when you were installing
components. You must re-connect these cables before you replace
the chassis cover.
The figures below show the front panel cables and their corresponding
connectors on the motherboard.
Power Switch
Line Out / Mic
USB Connector (USB2P)
1. Connect the power switch and power LED cables to their
respective leads in the PANEL connector on the motherboard.
2. Connect the HDD LED cable to the 2-pin lead marked IDELED.
3. Connect the Line Out/Mic cable to the FLOUT/MIC2 connector
on the motherboard, matching the red pin stripe with Pin 1.
4. Connect the USB2P cable to the USB1 connector on the
motherboard, matching the red pin stripe with Pin 1.
ASUS Terminator Barebone System
Power LED
HDD LED
USB1 Connector
Speaker
Connector
Power LED
PANEL Connector
IDELED Lead
Pin 1
FLOUT Lead (for Line Out Cable)
MIC2 Lead (for Microphone Cable)
Speaker
Ground
Ground
Reset
Ground
ATX Power
+5V
Ground
Switch*
PWR
Ground
ExtSMI#
TB_LED
PLED
Message LED
+5 V
+5 V
Requires an ATX power supply.
*
Reset SW
SMI Lead
25
Advertisement
Table of Contents
