Boot Sequence - Dell XPS 210 Owner's Manual

POST Hotkeys
Keyboard Errors

Boot Sequence

This feature allows you to change the boot sequence for devices.
NOTICE:
If you modify any boot sequence settings, save the new settings to avoid losing the changes.
Option Settings
• Diskette Drive — The computer attempts to boot from the floppy drive. If the floppy disk in the drive is
not bootable, the computer generates an error message. If no floppy disk is in the drive, or if there is no
floppy drive installed in the computer, the computer attempts to boot from the next bootable device in the
boot sequence.
• Hard Drive — The computer attempts to boot from the primary hard drive. If no operating system is
on the drive, the computer attempts to boot from the next bootable device in the boot sequence.
• CD Drive — The computer attempts to boot from the CD drive. If no CD is in the drive, or if the CD
has no operating system, the computer attempts to boot from the next bootable device in the boot
sequence.
• USB Flash Device — Insert the memory device into a USB port and restart the computer. When
= Boot Menu
device and adds the USB flash option to the boot menu.
NOTE:
To boot to a USB device, the device must be bootable. To make sure that your device is bootable, check the
device documentation.
Changing Boot Sequence for the Current Boot
You can use this feature, for example, to boot your computer to a USB device such as a floppy drive or
memory key.
1 If you are booting to a USB device, connect the USB device to a USB connector (see "Front and Back
View of the Computer" on page 13).
2 Turn on (or restart) your computer.
3 When the DELL logo appears, press <F12> immediately.
NOTE:
Keyboard failure may result when a key on the keyboard is held down for extended periods of time. To
avoid possible keyboard failure, press and release <F12> in even intervals until the Boot Device Menu
appears.
If you wait too long and the operating system logo appears, continue to wait until you see the
Microsoft Windows desktop, then shut down your computer and try again.
106
Specifications
This option allows you to specify the function keys to display on the screen
when the computer starts.
This option disables or enables keyboard error reporting when the computer
starts.
appears in the upper-right corner of the screen, press <F12>. The BIOS detects the
F12