BMW SERIE 7 2004 Owner's Manual page 203

1 High beams
Press the tab down, refer to arrow.
Always wear gloves and eye protec-
tion – the atmosphere within the bulb
is pressurized. Failure to observe this pre-
caution can lead to personal injury should
the bulb be damaged.<
1 High beams
H7 bulb, 55 watts
1. Remove the cover
2. Turn the bulb holder to the left and
remove
3. Remove and replace the bulb.
Xenon lamps
The service life of these bulbs is very long
and the probability of a failure is very low,
provided that they are not switched on and
off an unusual number of times.
In the unlikely event that one of these
lamps should fail, you can respond by
switching on your fog lamps and proceed-
ing carefully, where allowed by law.
To avoid risk of potentially fatal inju-
ries: owing to the extremely high volt-
ages at which these units operate, service
work should always be entrusted to quali-
fied
Parking and standing lamps
In the event of a malfunction, please con-
tact your BMW center.
Turn signal indicator, front
Two bulbs – 3457AK or 3457NAK
1.
2.
Side-mounted turn signal indicators
Bulb 5 watts – W 5 W
1.
2.
3.
4.
Online Edition for Part No. 01 41 0 157 670 - © 08/03 BMW AG
personnel.<
Turn the bulb holder to the left and
remove
Apply gentle pressure to the bulb while
turning it to the left for removal and
replacement.
Press against the front edge of the lamp
with the tip of your finger, then push it to
the rear and release the detent at the
front
Turn the lamp 90 3 and remove
Turn the bulb holder to the left and
remove
Extract the bulb for replacement.
201
*