Related Manuals for Jensen MCD5060
Summary of Contents for Jensen MCD5060
- Page 1 MCD5060 MARINE CD PLAYER / RECEIVER Installation and Operation Manual MCD5060...
-
Page 2: Safety Information
MCD5060 SAFETY INFORMATION DISC NOTES Compatible Disc Types When Driving Keep the volume level Iow enough to be aware of the road and traffic conditions. Table 1: General Disc Information Protect from Water Do not expose the product directly to water, as this can cause electrical shorts, fire or other Diameter/ damage. -
Page 3: Installation
MCD5060 Follow the wiring diagram carefully and make certain all connections are secure and INSTALLATION insulated with crimp connectors or electrical tape to ensure proper operation. Before You Begin After completing the wiring connections, attach the front panel and turn the unit on to confirm operation (vehicle ignition switch must be on). -
Page 4: Din Rear-Mount (Method B)
MCD5060 DIN Rear Mount (Method B) • The DCP can easily be damaged if dropped or subjected to a strong shock. When the release button is pressed and the DCP is unlocked, the vehicle's vibrations may cause it This unit has threaded holes in the chassis side panels which may be used with the original to fall. - Page 5 MCD5060 WIRING 688A ANTENNA JACK ANTENNA SOCKET FUSE 20-PIN AUDIO/POWER HARNESS (See Figure 1) RCA-TO-RCA CABLE (not supplied) WHITE REAR LINE OUT GREY Figure 1: 20 PIN HARNESS PIN CHART BLUE Power Antenna Connect to power antenna or amplifier, If not used, tape bare end of wire.
-
Page 6: Basic Operation
MCD5060 BASIC OPERATION Clock Adjustment With the clock displayed, press the D button (18) until the LCD flashes. Press the up >>| (21) button to adjust the hours or the down |<< button (20) to adjust the minutes. Reset After releasing the control panel, use a pencil or any non-metallic object to press and hold the RESET button for five seconds to reset the main unit. -
Page 7: Tuner Operation
MCD5060 TUNER OPERATION Store a Station Select a band (if needed), then select a station. Hold a preset button (12-17) for three seconds. The preset number will appear in the display. Recall a Station Select a band (if needed). Press a preset button (12-17) to select the corresponding stored station. -
Page 8: Controlling Disc Playback
MCD5060 CD OPERATION MCD5060 Insert and Eject Disc Insert a disc, label-side up, with the unit turned on. “S-CDP” will display on the LCD for about 2 seconds and the unit will play the first track on the disc. Press the eject button (2) to stop disc play and eject the disc. -
Page 9: Specifications
MCD5060 SPECIFICATIONS TROUBLESHOOTING Signal to Noise Ratio..........> 70dB... - Page 10 MCD5060 ASA Electronics Corporation www.asaelectronics.com © 2006 ASA Electronics Corporation v.071806...