Table of Contents
Advertisement
Removing and Reinstalling Front Panel
The projector can project an image from 60 to 300 inches diagonal. From the factory the projector is set for ceiling mount, 100 inch
diagonal screen size and a projection angle of 12.4 degrees. The projector can be used in three other degree applications.
Before the following procedures, remove the front panel by loosening the two screws B which hold the front panel. There are two
screws on each side.
Screws B
• Reverse the preceding steps to reinstall the front panel.
Screen Size Change(Adjusting Focus Rings and CRT Angle) for XG85
• Adjusting Focus Rings for the XG85
There are three sets of adjusting focus rings, two between each CRT and lens.
These focus rings are used for maintaining optimum edge focus for the various screen sizes and projection angles.
*When setting the focus rings or changing CRT angle, you must first remove the front panel.
1 Loosen the four screws at the lens.
CAUTION: Be careful not to remove any of the four screws
completely. The falling lens can cause serious injury especially
when the projector is installed on the ceiling.
PROJECTION CONFIGURATION CHANGE
Screws
Screws
15
Advertisement
Table of Contents
