SMC Networks 2804WBRP-G - annexe 2 Quick Installation Manual page 6

Introduction
Configuring your Macintosh
Once you have connected the Barricade
Broadband modem, then connected your Macintosh to the
Barricade TM g, you are ready to configure your computer to
connect to your Barricade TM g.
Once you have connected these devices, using CAT-5 Ethernet
cabling, please check the Barricade
you have a good connection.
• The WAN light verifies that you have good connection from
your broadband modem to the Barricade
• The PORT light verifies that you have a good connection
between a computer and the Barricade
display the connection speed (10Mbps or 100Mbps). If you
connect all the devices together and don't get a valid WAN /
PORT light status, then please check the cables.
Configuring TCP/IP Settings
Once you have verified that you have a good network
connection to all of your devices, then you will need to check
your computers network settings. To do this, please follow the
steps to the right:
1. Pull down the [Apple] menu, then click the [Control Panels]
option and select [TCP/IP].
2. In the [TCP/IP] dialog box, make sure that [Ethernet] is
selected in the [Connect Via:] field.
9
TM g Router to your
TM g port lights to verify that
TM g.
TM g. This light will also
Introduction
If [Using DHCP Server]
is already selected in
the [Configure] field, then
your computer is already
configured for a DHCP
connection. Please verify your IP
information against the
information outlined below:
• IP address is now
192.168.2.xxx (Where xxx
is a number from 1-253).
• Subnet Mask is 255.255.255.0.
• Default Gateway is 192.168.2.1.
If you have that information listed
in your IP information then you are
ready to configure the Barricade TM
Please go to: Disable HTTP Proxy.
If not, then please continue with
the following steps.
3. Set the [Configure] option to
[Using DHCP Server] then
close the [TCP/IP] dialog box and
you will be prompted to save the settings.
4. Click the [Save] button to
save the new changes.
Step 1
g.
Step 2
Step 4
10