Replacing The Hard Drive - Dell Inspiron 8600 Owner's Manual

Replacing the Hard Drive

NOTE: You need the
system. You also need the
utilities on the new hard drive.
CAUTION: If you remove the hard drive from the computer when the drive is hot,
do not touch
the metal housing of the hard drive.
CAUTION: Before working inside your computer, read the safety instructions at
the front of this document (see page 11).
NOTICE: To prevent data loss, turn off your computer (see page 42) before removing the hard
drive. Do not remove the hard drive while the computer is on, in standby mode, or in hibernate
mode.
NOTICE: Hard drives are extremely fragile; even a slight bump can damage the drive.
NOTE: Dell does not guarantee compatibility or provide support for hard drives from sources
other than Dell.
To replace the hard drive in the hard drive bay:
Ensure that the work surface is flat and clean to prevent scratching the computer
1
cover.
Save and close any open files, exit any open programs, and then shut down the
2
computer (see
page 42
If the computer is connected to a docking device (docked), undock it. See the
3
documentation that came with your docking device for instructions.
Disconnect the computer from the electrical outlet.
4
Wait 10 to 20 seconds, and then disconnect any attached devices.
5
Remove any installed PC Cards, batteries, and module bay devices.
6
NOTICE: Handle components and cards by their edges, and avoid touching pins and contacts.
Ground yourself by touching a metal connector on the back of the computer. Continue to ground
yourself periodically during this procedure.
Operating System CD to install the Microsoft
Drivers and Utilities
).
®
Windows
CD for your computer to install the drivers and
Adding and Re placing Parts
®
operating
125