Setting Up a Printer
CAUTION: Before performing these procedures, read the safety instructions on
page 11.
NOTICE: Complete the operating system setup before you connect a printer to the computer.
See the documentation that came with the printer for setup information, including how to:
•
Obtain and install updated drivers.
•
Connect the printer to the computer.
•
Load paper and install the toner or ink cartridge.
•
Contact the printer manufacturer for technical assistance.
Printer Cable
Your printer connects to your computer with either a USB cable or a parallel cable. Your
printer may not come with a printer cable, so if you purchase a cable separately, ensure that
it is compatible with your printer. If you purchased a printer cable at the same time you
purchased your computer, the cable may arrive in the computer box.
Connecting a Parallel Printer
Complete the operating system setup, if you have not already done so.
1
Shut down the computer (see "Turning Off Your Computer" on page 42).
2
NOTICE: For best results, use a 3-m (10-ft) or shorter parallel cable.
Attach the parallel printer cable to the parallel connector on the computer and tighten
3
the two screws. Attach the cable to the connector on the printer and snap the two clips
into the two notches.
38
Se tti n g U p Yo ur Co m p ute r