Specifications - NAD T765 Specifications

> S P E C I F I C A T I O N S
POWER AMPLIFIER SECTION
Minimum continuous Power (FTC)
Power output, Stereo Mode
Simultaneous Full Disclosure Power
IHF dynamic power, 8Ω
IHF dynamic power, 4Ω
IHF dynamic power, 2Ω
Rated THD
IM distortion, rated power
Damping factor, 8Ω
Input sensitivity and impedance
Frequency response
Signal/Noise ratio
PREAMPLIFIER SECTION
Input sensitivity and impedance
Frequency response
Signal/Noise ratio
AM BAND
Frequency range
Usable sensitivity
Signal/Noise ratio
Total Harmonic Distortion
Loop sensitivity 20dB S/N
FM BAND
Usable sensitivity, Mono
Signal/Noise ratio, Mono
Signal/Noise ratio, Stereo
Total Harmonic Distortion, Mono
Total Harmonic Distortion, Stereo
Channel Separation, 1kHz
Frequency response
RDS decode sensitivity
140W
120W
(ref. 4/8Ω, both channels driven
at rated distortion)
7 x 80W
(ref. 4/8Ω, all channels driven
at rated distortion)
160W
260W
360W
<0.08% (ref. 20Hz – 20kHz)
<0.08%
>60
1.1V / 50kΩ
±0.8dB (ref. 20Hz – 20kHz)
>92dB (ref. rated power, 8Ω, A-weighted)
>82dB (ref. 1W, 8Ω, A-weighted)
350mV / 50kΩ
±0.5dB (ref. 20Hz – 20kHz)
>88dB (ref. 2V, A-weighted)
530kHz - 1710kHz (120V version only, 10kHz steps)
531kHz - 1602kHz (230V version only, 9kHz steps)
30dBu
>38dB
<3%
66dBu
<16.1dBf
60dB
55dB
0.25%
0.5%
40dB
±1.5dB (ref. 30Hz – 15kHz)
28dBu
DIMENSIONS AND WEIGHT
Dimensions (W x H x D)
Net Weight
Shipping Weight
* Gross dimensions include feet, extended buttons and rear panel terminals.
Note: Installers should allow a minimum clearance of 55mm for
wire/cable management.
435 x 170 x 431mm (Gross)
19.8kg
24.7kg