Playing A Disc; Selecting A Desired Track/Passage; Program Tracks - LENCO MC-133 MP3 Manual

U SING THE CD/MP3
LOADING A DISC
1. Press the FUNCTION switch to select CD/MP3 playing mode.
2. Open the CD door.
3. Place an audio CD/MP3 into the tray with the label side facing up.
4. Close the CD door.
CD READ
The display will show
appear in the display after 5 seconds.
11 47: 12
Example :
5. To rem ove the CD, press OPEN to open CD com partm ent lid, the display will show OPEN .
Grasp the CD by its edges, and carefully take it out.
Note:
To ensure good system performance; wait until the disc tray completely reads the disc before
proceeding.
If no disc loaded into the com partm ent, or the disc is unreadable, the display will show no
disc.

PLAYING A DISC

1. Press PLAY/ PAUSE button to start playback. The playback starts from track 1, PLAY
appears in the display.
2. To interrupt playback, press PLAY/ PAUSE button. The elapsed tim e will flash on and off in
00:57
the display. Example: flashes on and off.
3. To resume playback, press PLAY/PAUSE button again.
4. To stop playback, press STOP button, the total num ber of tracks and playing tim e will
appear in the display

SELECTING A DESIRED TRACK/PASSAGE

To select a desired track
Press TUNING CONTROL/ CD SKIP UP/ DOWN CONTROL button repeatedly in stop m ode
or during playing until the desired track appears on the display.
Press PLAY/PAUSE button to start play.
To s e arch fo r a p articu lar p a s s age d u rin g p la yback ( track s can n in g at h igh
speed)
Press and hold TUNING CONTROL/ CD SKIP UP/ DOWN CONTROL button to scan the
current playing track at high speed until desired point (passage), then release the button.
Playback will start again from this point.

PROGRAM TRACKS

Program tracks of disc are possible when playback is stopped. Up to 64 tracks can be stored in
the memory in any order.
1. In stop m ode, press MEMORY button on the rem ote handset to enter program setting, the
00 P -- 01
display will show .
2. Press TUNING CONTROL/ CD SKIP UP/ DOWN CONTROL to select the first desired track
to be programmed. (example: track 6)
3. Press MEMORY button to enter. The display changes to show
4. Repeat steps 2 & 3 to store other desired tracks until all tracks programmed.
5. Press PLAY/ PAUSE button to start playback from the first program m ed track. The display
06 00:01
will show .
, then the total number of tracks and playing time will
00 P -- 02
E-6
.