Using The Sony Tv Direct Function; Preparation; Operation - Sony DAV-SB100 Operating Instructions Manual

Using the SONY TV DIRECT Function

SONY TV DIRECT allows you to turn on your SONY TV
and this system, change the system mode to "CD/DVD,"
and then switch the TV's input source you set with one
button push.

Preparation

Register the TV's input source connected to this
system.
Press and hold TV/VIDEO while entering the
1
code for the TV's input source to connect this
system (see table below) using the number
buttons.
TV's input source is selected
If you successfully set the TV's input source code,
the TV button flashes twice slowly. If the setting is
unsuccessful, the TV button flashes five times
quickly.
SONY TV DIRECT
TV
2
Number buttons
TV/VIDEO

Operation

Point the remote to the direction of TV and this system,
TV CH +/- then press SONY TV DIRECT once.
While transmitting the code from the remote, the TV but-
ton flashes.
Notes
By pressing Number TV's input source
TV/VIDEO 0 No input source
(Default)
1 VIDEO1
2 VIDEO2
3 VIDEO3
4 VIDEO4
5 VIDEO5
6 VIDEO6
7 COMPONENT 1
INPUT
8 COMPONENT 2
INPUT
Press and hold TV CH + while entering the code
for transmit time (see table below) using the
number buttons.
The transmit time from the remote is selected.
If you successfully set the transmit time code, the
TV button flashes twice slowly. If the setting is
unsuccessful, the TV button flashes five times
quickly.
By pressing Number Transmit time
TV CH + 1 0.5 (Default)
2 1
3 1.5
4 2
5 2.5
6 3
7 3.5
8 4
The function is only for SONY TV series.
If this function does not work, change the transmit
time. The transmit time varies depending on the TV.
If distance between TV and this system is too far, this
function may not work. Install the system near the TV.
Keep the remote pointed in the direction of the TV
and this sysetm whlie the TV button is flashing.
33