Rear Panel View
B
1. AM Aerial Connector Terminals
2. FM Aerial Connector Terminal
3. DAB Aerial Connector Terminal
4. CD Digital Out(optical)
5. AUX-Input
6. Loudspeaker Connector Terminals
6
Where to Install Your
Micro Component System
To take full advantage of your new micro component system,
follow these installation instructions before connecting the unit.
Install the system on a flat, stable surface.
Never place this unit on carpeting.
Never place this unit in an outdoor area.
Maintain an open space of approximately 6 inches (15 cm) on the
sides and rear of the system, for ventilation purposes.
Make sure that you have enough room to open the compact disc
compartment easily.
1
Place the loudspeakers at a reasonable distance on either side of
the system to ensure good stereo sound.
Direct the loudspeakers towards the listening area.
For optimum performance, make sure that both speakers are placed
2
at an equal distance above the floor.
3
4
5
6
Connecting your System to the
Power Supply
The main lead must be plugged into an appropriate socket.
Before plugging your system into a main socket, you must check
the voltage.
1
Plug the main lead into an appropriate socket.
2
Press the (
Inserting Remote Control Batteries
Insert or replace remote control batteries when you:
Purchase the micro component system
Find that the remote control is no longer operating correctly
When replacing the batteries, use a new set of batteries and
never mix alkaline and manganese batteries.
1
Place your thumb on the position marked
compartment cover (rear of the remote control) and push the cover in
the direction of the arrow.
2
Insert two AAA, LR03 or equivalent batteries, taking care to respect
the polarities:
3
Replace the cover by sliding it back until it clicks into position.
) button to switch your micro component system on.
on the battery
+ on the battery against + in the battery compartment
– on the battery against – in the battery compartment
7
GB