Connecting The Video To Tv; Connecting The Fm And Am(Mw) Antennas - Samsung HT-DB7090 Instruction Manual

Digital home theater system
Table of Contents

Advertisement

Connecting the Video to TV

*
Depending on your TV, Component Video input connectors may be marked as DVD Video input connectors.
Composite Video (Good Quality)
Connect the supplied video cable from the VIDEO OUT jack on the back panel of the
system to the VIDEO IN jack on your television.
S-Video (Better Quality)
If you television is equipped with an S-Video input, connect an S-Video cable (not supplied)
from the S-VIDEO OUT jack on the back panel of the system to the S-VIDEO IN jack on
your television.
Component Video (Best Quality)
If your television is equipped with Component Video inputs, connect a component video
cable (not supplied) from the Pr, Pb and Y jacks on the back panel of the system to the
corresponding jacks on your television.
When the Progressive scan mode is selected, the VIDEO and S-VIDEO outputs do not feed
Note
any signals. See page 14 to select Progressive Scan.
13
TV
Component
Composite
S-Video
Video
Video
Connecting the FM and AM
If AM reception is poor, connect an
outdoor AM antenna(not supplied).
If FM reception is poor,
connect an outdoor FM
antenna (not supplied).
FM Antenna (supplied)
FM antenna connection
1. Connect the FM antenna supplied to the FM 75
COAXIAL terminal as a temporary measure.
2. Slowly move the antenna wire around until you
find a location where reception is good, then
fasten it to a wall or other rigid surface.
• If reception is poor, connect an outdoor antenna.
Before attaching a 75 coaxial cable (with a standard
type connector), disconnect the supplied FM antenna.
The cooling fan dissipates the heat generated inside the unit so that the unit can be operated
Cooling Fan
normally. The cooling fan is activated automatically to supply cool air to the unit.
Please observe the following cautions for your safety.
Make sure the unit is well-ventilated. If the unit has poor ventilation, the temperature inside the unit could rise
and may damage it.
Do not obstruct the cooling fan or ventilation holes. (If the cooling fan or ventilation holes are covered with a
newspaper or cloth, heat may build up inside the unit and fire may result.)
Antennas
( MW )
1
2
3
AM Loop Antenna
(supplied)
Snap the tabs on the loop into the
slots of the base to assemble the
AM loop antenna.
AM
antenna connection
(MW)
1. Connect the AM loop antenna supplied
to the AM and
terminals.
2. If reception is poor, connect an outdoor
single vinyl-covered wire to the AM
terminal. (Keep the AM loop antenna
connected).
14

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ht-db600

Table of Contents