Turning The Power On; Turning The Power Off - Roland Edirol M-16DX Owner's Manual

Turning the power on

Once the connections have been completed (p. 21 — p. 24),
turn on power to your various devices in the order specified.
By turning on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other devices.
1.
Set the channel LEVEL knobs to the "U"
position.
fig.Adj-Ch-Level
2.
Set the MAIN MIX LEVEL knob and PHONES/
CTRL ROOM knob to the "-∞" position.
* Minimize the MAIN MIX LEVEL and PHONES/CTRL
ROOM volume controls before you turn the power on. Even if
the volume is minimized, you may hear some noise when you
turn on the power, but this is not a malfunction.
fig.Adj-MAIN MIX
3.
Switch on the power to your digitally connected
equipment.
4.
Switch on the power to your analog-connected
equipment (musical instruments, sound
modules, effects processors, mics, CD players,
etc.).
5.
Turn on the M-16DX's [POWER] switch (I/O
module).
The POWER indicator will light.
After the power is turned on, the display will show the
level meter screen.
fig.03-Setup
6.
Switch on the power to your amp and powered
monitors.

Turning the power off

1.
Make sure you've done the following before you
turn off the power.
• The M-16DX's MAIN MIX LEVEL knob has been set to
the "-∞" position.
• The volume of the connected equipment has been
minimized.
2.
Switch off the power to your amp and powered
monitors.
3.
Turn the M-16DX's [POWER] switch (I/O
module) off.
4.
Switch off the power to your analog-connected
equipment (musical instruments, sound
modules, effects processors, mics, CD players,
etc.).
5.
Switch off the power to your digitally connected
equipment.
Basic use
25