Troubleshooting - Panasonic SR-LE10 Operating Instructions Manual

Troubleshooting

Problem
G
Rice is not cooked at
a preset time.
G
Cooking started as
soon as timer cooking
was activated.
G
Key functions were
disabled.
G
Pressing the [Start]
key did not activate
the cooking function.
G
Steam escaped from
other than the steam
vent.
G
Power failed while
the rice cooker was
in operation.
G
The rice cooker
produced sounds
while the unit was in
the cooking or the
keep warm mode.
Error Code
2 or 3 indication lamps
flash together
❈ Replace damaged or deformed pan.
❈ Consult your nearest retailer or service center if rice, water or other material is put directly into the main unit
without using the pan.
❈ The marks (G,
41
G
The [Start] key was not pressed.
G
The timer was set to a time shorter than the minimum time required
for cooking. ( Page 29)
G
The rice cooker was disconnected from an electrical outlet.
G
The [Start] key was pressed while the [Keep Warm/off] lamp was
lit.
G
The packing of the lid or the brim of the pan was deformed or rice
was stuck to them.
G
The cooking finishing time may be delayed.
G
Cooking may not be done properly depending on the length of
power failure.
G
Clicking sounds are produced by power adjustments.
G
Popping sounds are produced when bursts of steam escape from
between the pan and the heating plate. Over time this will damage
the heater and pan, so it is important to keep them dry before
using the unit.
G
Consult your nearest retailer or service center for repair.
) above the [Start] and the [Keep Warm/Off] keys are for blind people.
(Check the following items before you
contact your retailer or service center.)
Possible Cause (Reference page)
Cooking starts upon activation of the timer cooking function
under such contitions.
Possible Cause