MSI K9NGM Series User Manual page 55

M S-7252 M ainboard
Re-call VGA BIOS from S3
Selecting [Enabled] allows BIOS to call VGA BIOS to initialize the VGA card when
system wakes up (resumes) from S3 sleep state. The system resume time is short-
ened when you disable the function, but system will need an AGP driver to initialize
the VGA card. Therefore, if the AGP driver of the card does not support the initializa-
tion feature, the display may work abnormally or not function after resuming from S3.
Power Button Function
This feature sets the function of the power button. Settings are:
[On/ Off]
[Suspend]
Restore On AC Power Loss
This item specifies whether your system will reboot after a power failure or interrupt
occurs. Settings are:
[Off]
[On]
[Last State]
Wakeup Event Setup
Press <Enter> and the following sub-menu appears.
Resume From S3 by PS/2 KB
This controls how the PS/2 keyboard is able to power on the system. If you
choose Specific Key, the power button on the case will not function anymore
and you must type the password to power on the system.
Resume From S3 by PS/2 MS
This setting determines whether the system will be awakened from what power
saving modes when input signal of the PS/2 mouse is detected.
Resume by PCI Device (PME#)
W hen set to [Enabled], the feature allows your system to be awakened from the
power saving modes through any event on PME (Power Management Event).
3-16
The power button functions as normal power off button.
W hen you press the power button, the computer enters the
suspend/sleep mode, but if the button is pressed for more
than four seconds, the computer is turned off.
Always leaves the computer in the power off state.
Always leaves the computer in the power on state.
Restores the system to the status before power failure
or interrupt occurred.