Table of Contents
Advertisement
Re-Call VGA BIOS at S3 Resuming
Selecting [Enabled] allows BIOS to call VGA BIOS to initialize the VGA card
when system wakes up (resumes) from S3 sleep state. The system resume time
is shortened when you disable the function, but system will need an AGP driver
to initialize the VGA card. Therefore, if the AGP driver of the card does not
support the initialization feature, the display may work abnormally or not func-
tion after resuming from S3.
Power Management/APM
Setting to [Enabled] will activate an Advanced Power Management (APM)
device to enhance Max Saving mode and stop CPU internal clock. Settings:
[Disabled], [Enabled].
Suspend Time Out (Minute)
After the selected period of system inactivity, all devices except the CPU shut
off. Settings: [Disabled], [1], [2], [4], [8], [10], [20], [30], [40], [50], [60].
Power Button Function
This feature sets the function of the power button. Settings are:
[On/Off]
The power button functions as normal power off button.
[Suspend]
When you press the power button, the computer enters
the suspend/sleep mode, but if the button is pressed for
more than four seconds, the computer is turned off.
Restore on AC/Power Loss
This setting specifies whether your system will reboot after a power failure or
interrupt occurs. Available settings are:
[Power Off]
Leaves the computer in the power off state.
[Power On]
Leaves the computer in the power on state.
[Last State]
Restores the system to the previous status before power
failure or interrupt occurred.
Set Monitor Events
Press <Enter> and the following submenu appears.
4-15
BIOS Setup
Advertisement
Table of Contents
