Checking The Backup Battery - Lenovo ThinkPad W520 4284 Hardware Maintenance Manual

Note: If the battery pack becomes hot, it may not be able to charge. Remove it from the computer and leave
it at room temperature for a while. After it cools down, reinstall and recharge it.
To check the battery pack, do the following:
1. Power off the computer.
2. Remove the battery pack and measure the voltage between battery terminals 1 (+) and 7 (-). See the
following figure:
1(+)
3. If the voltage is less than +11.0 V dc, the battery pack has been discharged.
Note: Recharging will take at least 3 hours, even if the indicator does not turn on.
If the voltage is still less than +11.0 V dc after recharging, replace the battery.
4. If the voltage is more than +11.0 V dc, measure the resistance between battery terminals 5 and 7.
The resistance must be 4 to 30 K Ω. If the resistance is not correct, replace the battery pack. If the
resistance is correct, replace the system board.

Checking the backup battery

Do the following:
1. Power off the computer, and unplug the ac adapter from it.
2. Turn the computer upside down.
3. Remove the battery pack (see 1010 Battery pack).
4. Remove the backup battery (see 1120 Backup battery).
5. Measure the voltage of the backup battery. See the following figure.
• If the voltage is correct, replace the system board.
• If the voltage is not correct, replace the backup battery.
• If the backup battery discharges quickly after replacement, replace the system board.
34
ThinkPad T520, T520i, and W520 Hardware Maintenance Manual
7(-)
6(-)
5
3 4
2(+)
Terminal Voltage (V dc)
1 + 0 to + 12.6
7 Ground (-)
Wire Voltage (V dc)
Red +2.5 to +3.2
Black Ground