Determining If Tcp/Ip Is Installed; Installing Tcp/Ip; Configuring A Ppp Connection - 3Com 56K Command Reference Manual

1-10 C 1: C
HAPTER ONNECTING TO
Determining if TCP/IP
is installed

Installing TCP/IP

Configuring a PPP
connection
Y ISP
OUR
8 Click Network.
9 Select the protocols required to dial in and out with your Business
Modem.
10 Set Encryption Settings to Allow any authentication including clear
text.
11 Click Continue to complete RAS setup.
TCP/IP must be installed before you can access the Internet. Although this
is a standard configuration, double-check to make sure TCP/IP is installed.
To determine if TCP/IP is installed, perform the following actions:
1 Select Start | Settings | Control Panel
2 Double-click Network
3 On the Protocol tab, scan down the list of installed protocols to find
TCP/IP Protocol Adapter.
4 If TCP/IP Protocol is listed, skip to section Configuring a PPP Connection.
If TCP/IP Protocol is NOT listed move to the next section.
To install TCP/IP, perform the following actions:
1 Select Start | Settings | Control Panel
2 Double-click Network
3 On the Protocol tab, click Add, and select the TCP/IP protocol from the
list.
To configure the Business Modem for a PPP connection, perform the
following actions:
1 Go to Start | Programs | Accessories | Dial Up Networking
2 Click New.
3 Select the Server tab and select PPP in the Dial-up server type box.
4 Select TCP/IP
5 Deselect NetBEUI and IPX.
6 If you are connecting to an ISP, uncheck Enable PPP LCP Extensions
If you are connecting to another Windows NT system, Check Enable PPP
LCP Extensions