Icom IC-PCR1500 Instruction Manual page 47

Icom ic-pcr1500 communication receiver: instruction manual
Hide thumbs Also See for IC-PCR1500:
Table of Contents

Advertisement

o IF-SHIFT INDICATOR (p. 61)
Indicates the received signal passband position.
!0 IF-FILTER PASSBAND WIDTH INDICATOR (p. 58)
Indicates the current signal passband width.
!1 MAXIMUM FREQUENCY SPAN INDICATORS (p. 99)
Indicates the upper and lower observable frequency lim-
its around a receive frequency.
In the diagram, the upper and lower limits are ± 500
kHz.
!2 LIMIT/PAUSE INDICATOR (p. 99)
"LIMIT" appears when the tuning step (e) is larger than
the automatic sweep step (!3 ) setting.
• The limit indicator is not indicated when the tuning step and
the sweep step width are the same.
"PAUSE" appears while the band scope is pausing.
!3 FREQUENCY SPAN INDICATOR (p. 99)
Indicates the frequency span selected with the [SPAN +]
or [SPAN –] button.
!4 CENTER FREQUENCY INDICATOR (p. 99)
Indicates the center frequency of the frequency span; this
is for the currently received frequency.
!5 SWEEP STEP INDICATOR (p. 99)
Indicates band scope sweep step.
!6 AFC INDICATOR [AFC] (p. 59)
Appears when the AFC (Automatic Frequency Control)
function is ON.
PANEL DESCRIPTION
!7 ATTENUATOR INDICATOR [ATT] (p. 59)
Appears when the ATT (Attenuator) function is ON.
!8 TSQL/DTCS INDICATOR [TSQL]/[DTCS]
"TSQL" appears when the tone squelch frequency is set.
(p. 94)
"DTCS" appears when DTCS code and the polarity are
set. (p. 95)
!9 REVERSE/POCKET BEEP INDICATOR [R]/
"[R]" appears when the reverse action is set.
(pgs. 94, 95)
"
" appears when the pocket beep function is set.
(p. 96)
@0 VSC INDICATOR [VSC] (p. 61)
Appears when the VSC (Voice Squelch Control) function is
ON.
@1 AGC INDICATOR [AGC-F] (p. 60)
"AGC-F" appears when the AGC fast is selected.
@2 NB INDICATOR [NB] (p. 60)
Appears when the NB (Noise Blanker) function is ON.
@3 FREQUENCY/TIME INDICATOR [FREQ]/[TIME] (p. 99)
"FREQ" appears when Frequency mode is selected in
the band scope operation.
"TIME" appears when Time mode is selected in the
band scope operation.
@4 TIME INTERVAL INDICATORS (p. 99)
Indicates the time interval to sweep the receiving signal.
4
4
39

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ic-pcr2500

Table of Contents