Installing A Hard Disk Drive; To Replace The Hard Disk Drive - HP OmniBook 4100 Reference Manual

Installing a Hard Disk Drive

This section describes how to
Replace the hard disk drive.
Replace the hard disk drive holder.
Create a hibernate partition for a new hard disk drive.

To replace the hard disk drive

You'll need a small Phillips screwdriver for this procedure.
1. Unplug the ac adapter, if present, and remove the battery.
2. Turn the unit bottom side up.
3. Remove the hard drive screw from the bottom case.
4. Pull out the hard drive by its plastic tab.
If you are installing a new hard disk drive, you should create a Hibernate partition on
the drive before loading any software—see page 5-6 for instructions.
Expanding the OmniBook
5-3