Mounting To Shop Floor - Grizzly G0608X Owner's Manual

Mounting to Floor
3.
Position lifting straps, your lifting device, and
your assistant to support the shaper in a verti-
cal and stable position.
4. Unbolt the shaper from the pallet.
5. Slowly raise the shaper from the pallet, then
carefully move the shaper to your prepared
location.
6. Follow the Mounting To Shop Floor proce-
dures.
Mounting to Shop
Floor
The Model G0608X is designed to be mounted to
the floor. Because floor materials may vary, floor
mounting hardware is not included.
Bolting to Concrete Floors
Lag shield anchors with lag bolts (see Figure 8)
and anchor studs (see Figure 9) are two popular
methods for anchoring an object to a concrete
floor. We suggest you research the many options
and methods for mounting your machine, and
choose the best that fits your specific application.
NOTICE
Anchor studs are stronger and more per-
manent alternatives to lag shield anchors;
however, they will stick out of the floor,
which may cause a tripping hazard if you
decide to move your machine.
G0608X Extreme Series Tilting Spindle Shaper
Figure 8. Typical lag shield anchor and lag bolt.
Figure 9. Typical anchor stud.
-15-