Gigabyte GA-8GEMT4 Series User Manual page 22

9 ) F_PANEL (2x10 pins connector)
2
1
HD (IDE Hard Disk Active LED)
(Blue)
SPK (Speaker Connector)
(Amber)
RES (Reset Switch)
(Green)
PW (Soft Power Connector)
(Red)
MSG(Message LED/Power/
Sleep LED)(Yellow)
NC( Purple)
Ø Please connect the power LED, PC speaker, reset switch and power switch etc of your chassis
front panel to the F_PANEL connector according to the pin assignment above.
10) F_AUDIO (Front Audio Connector)
10 9
Rear Audio (L)
Rear Audio (R)
POWER
GND
2 1
11) SUR_CEN
BASS_OUT CENTER_OUT
GND
SUR OUTL
SUR OUTR
1
GA-8GEMT4 Series Motherboard
1
1
1
1
1
Pin 1: LED anode(+)
Pin 2: LED cathode(-)
Pin 1: VCC(+)
Pin 2- Pin 3: NC
Pin 4: Data(-)
Open: Normal Operation
Close: Reset Hardware System
Open: Normal Operation
Close: Power On/Off
Pin 1: LED anode(+)
Pin 2: LED cathode(-)
NC
Ø If you want to use "Front Audio" connector,
you must remove 5-6, 9-10 Jumper. In order to
utilize the front audio header, yourchassis must
Front Audio (L)
Reserved have front audio connector. Also please make
Front Audio (R)
sure the pin assigment on the cable is the same
REF
as the pin assigment on the MB header. To find
MIC
out if the chassis you are buying support front
audio connector, please contact your dealer.
Ø Please contact your nearest dealer for optional
SUR_CEN cable.
- 18 -
20
19