Positioning; Connections - Aiwa TS-W45 Operating Instructions Manual

L
1
If@@
,1
$.
,0
Ml
\
J
1
.
m"
-2,3
-.
Ji2J
10
0 0
ID
POSITIONING
Because low-frequency sound reproduced by the powered
subwoofer is mostly non-directional, the listener will be unable to
localize the bass source. Accordingly, the powered subwoofer
provides maximum flexibility in terms of positioning. For the most
effective low-frequency sound, the powered subwoofer should be
placed on the floor close to a wall or in a corner of the room.
CONNECTIONS
Connect the speaker cords before connecting the AC cord.
Connect in way if your stereo system has a SUPER
WOOFER output jack. [f not, connect in way.
Never connect in both of and ways simultaneously.
Connecting an AIWA stereo system with
a SUPER WOOFER or SUB WOOFER
output jack (RCA phono jack) to the
powered subwoofer
Preparations
Turn off the power of this unit.
1
2
Connect the SUPER WOOFER or SUB WOOFER jack on the
stereo system side ~ to the INPUT 1 (FROM SUPER
WOOFER TERMINAL) jack on the powered subwoofer O with
the supplied connecting cord.
Set the INPUT SELECT switch to"1".
Connecting a stereo system with typical
Land R speaker terminals to the powered
subwoofer
Preparations
Turn off the power of the stereo system and remove the speaker
cords from the speaker terminals on the system.
1
2
3
Connect the stereo system speaker terminals @to the INPUT
2 (FROM SPEAKERS OUT) terminals"on the powered
subwoofer @ with the supplied speaker cords 0.
Make sure the L and R and the @ and @ cords are connected
correctly.
Using the speaker cords removed in "Preparations" above,
connect the right and left speakers 6) 0 to the SPEAKERS
OUT terminals on the powered subwoofer Q).
Set the INPUT SELECT switch to "2.
Connecting the AC cord
Connect the AC cord to a wall outlet.
Use Iefffright speakers whose impedance corresponds with the
value specified on the stereo system.
6