Wall Mounting - HP J4902A Installation And Getting Started Manual

Installing the Switch 6108
Installation Procedures
4.
Install additional
screw

Wall Mounting

You can mount the switch on a wall as shown in the illustrations on the next
page.
W a r n i n g
For safe operation, do not install the switch with the back face of the
switch (with the fan vents) facing either downward or upward.
C a u t i o n
The switch should be mounted only to a wall or wood surface that is at least
1/2-inch plywood or its equivalent.
1.
2.
2-12
Install the other number 12-24 screw through the hole in each bracket.
Tighten these screws.
Use a #1 Phillips (cross-head) screwdriver and attach the mounting
brackets to the switch with the included 8-mm M4 screws.
Attach the switch to the wall or wood surface with two 5/8-inch number
12 wood screws (not included).