Installing Rack-Mount Brackets In The Middle Of The Chassis - Cisco UBR7225VXR Hardware Installation Manual

Chapter 3 Installing the Cisco uBR7225VXR Router
Figure 3-10
1 Rack-mount bracket
Step 3 Thread four M4 x 6-mm Phillips flathead screws through the rack-mount bracket and into the side of the
chassis. Use a number 2 Phillips screwdriver to tighten the screws.
Step 4 Repeat Step 1 through Step 3 for the other rack-mount bracket.
Step 5 If you plan to include the cable-management bracket in your front rack-mount configuration, align the
bracket with the two right front-side holes.
Thread two M3 x 6-mm Phillips panhead screws through the cable-management bracket and into the
Step 6
chassis, and tighten the screws.
This completes the procedure for installing the rack-mount brackets on the chassis for a front rack-mount
configuration. Proceed to the
To prevent injury, review the safety precautions in
Caution
Router for Installation,"

Installing Rack-Mount Brackets in the Middle of the Chassis

To install the rack-mount brackets and cable-management bracket at the middle of the chassis for a
telco-type rack-mount configuration, complete the following steps:
Locate the threaded holes in the middle sides of the chassis.
Step 1
Align the first rack-mount bracket to the threaded holes in the right side of the chassis. See
Step 2
There are five holes in each of the rack-mount brackets for the Cisco uBR7225VXR router. Four holes
Note
are used for front and middle mount, and five holes are used for rear mount.
OL-17309-01
Installing the Rack-Mount Brackets so the Front of the Chassis Protrudes Out of the
Rack
1
"Installing the Chassis in the Rack" section on page
before installing the universal broadband router in a rack.
Cisco uBR7225VXR Universal Broadband Router Hardware Installation Guide
Installing the Brackets on the Chassis
Chapter 2, "Preparing the Cisco uBR7225VXR
3-10.
Figure 3-11.
3-9