Table of Contents
Advertisement
Chapter 3
Configuring with the Command-Line Interface
The 1-port HSSI network module provides the following benefits:
•
•
•
Configuration Tasks
Perform the tasks in the following sections to configure a HSSI interface. The first task is required; the
remaining tasks are optional.
•
•
•
•
•
Specify a HSSI
To specify a HSSI and enter interface configuration mode, perform the following tasks in global
configuration mode:
Task
Begin interface configuration.
Specify HSSI Encapsulation
The HSSI supports the serial encapsulation methods, except for X.25-based encapsulations. The default
method is HDLC. You can define the encapsulation method by performing the following task in interface
configuration mode:
Task
Configure HSSI encapsulation.
For information about PPP, see the "Configure SLIP and PPP" chapter of the Cisco IOS Release 11.3
Access Services Configuration Guide and the "Configure PPP for Wide-Area Networking" chapter of the
Cisco IOS Release 11.3 Wide-Area Networking Configuration Guide.
OL-1957-03
Supports speeds up to 52 Mbps
Supports a range of connectivity options: ATM, Frame Relay, PPP, and SMDS
Supports EIA/TIA-612 and EIA/TIA-613 specifications at T3, E3, SONET OC1/STS-1 and NXT1
subrates
Specify a HSSI, page 3-47
Specify HSSI Encapsulation, page 3-47
Invoke ATM on a HSSI Line, page 3-48
Convert HSSI to Clock Master, page 3-48
Disable Fair Queueing, page 3-48
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
Configuring the 1-Port HSSI Network Module
Command
interface hssi slot/port
Command
encapsulation {atm-dxi | hdlc |
frame-relay | ppp | sdlc-primary |
sdlc-secondary | smds | stun}
3-47
Hide quick links:
Advertisement
Table of Contents
