Port Settings Configuration; Basic Port Configuration - D-Link DGS-3212SR User Manual

Port Settings Configuration

This section contains information for configuring various attributes and properties for individual physical ports,
including port security, traffic segmentation, port bandwidth control, serial port settings, and port mirroring.

Basic Port Configuration

To configure basic port settings such as port speed, duplex, and learning state use the Port Configuration menu.
Click the Port Configuration link in the Configuration folder:
To configure switch ports:
1. Choose the Unit from the pull-down menu.
2. Choose the port or sequential range of ports using the From...To... port pull-down menus.
3. Use the remaining pull-down menus to configure the parameters described below:
Parameter
State <Enabled>
Speed/Duplex
<Auto>
D-Link DGS-3212SR Layer 2 Gigabit Ethernet Switch
Figure 6-1. Port Configuration
Description
Toggle the State <Enabled> field to either enable or disable a given port.
Toggle the Speed/Duplex <Auto> field to either select the speed and
duplex/half-duplex state of the port. Auto – auto-negotiation between 10
and 100 Mbps devices, full- or half-duplex. The Auto setting allows the port
to automatically determine the fastest settings the device the port is
connected to can handle, and then to use those settings. The other options
are 100M/Full, 100M/Half, 10M/Full, and 10M/Half. There is no automatic
48
Section 6