Preparing And Using The Remote Control - CyberHome LDV 702 Owner's Manual

Preparing and Using the Remote Control

Installing the Battery
If the remote control only operates when you get closer to the DVD Player, may indicate that the battery is weak.
Please replace the battery (Lithium battery) simultaneously with new battery (CR 2025) of the same type.
Please note the positive (+) side is facing upwards on the remote.
1. Pull out the Battery Holder to remove
the battery compartment.
Remote Control
Important Note about the Battery
If the unit will not be used for an extended length of time, it's wise to remove the battery before storage.
The life of the battery depends on the amount of usage. With typical usage, a battery life of approximately 6
Operation of Remote Control
When using the Remote control, please aim at the device's remote control sensor, located on the
front of DVD Player. A 30 degree angle is recommended for best operation.
2. Insert new Battery into the
Battery Holder. Make sure that
Positive (+) side is facing upwards.
Bottom
8
3. Return the Battery Holder
back into the remote.
Remote Control
Bottom
Quick Tips
Make sure no objects
are between the remote
and the player.
Similar remote controls
could interfere with the
function of the player.
Make sure not to store
the remote upside
down or with any
objects pressing on the
buttons - this could
drain the battery.