Installing The Battery; Charging The Battery; Turning Your Phone On; Turning Your Phone Off - Motorola MOTORAZR V3 User Manual

Installing the Battery

Your phone is designed to use only Motorola Original
batteries and accessories.
1.
3.

Charging the Battery

New batteries are shipped partially charged. Before you can use
your phone, you need to install and charge the battery as described
below. Some batteries perform best after several full
charge/discharge cycles.
22 - Getting Started

Turning Your Phone On

Action
1 Press and hold the power key P
for 2 seconds to turn the phone on.
Note: It may take up to 4 seconds
for the display to illuminate after
you turn the phone on.
2 If necessary, enter your SIM card PIN code and press
(+) to unlock the SIM card.
OK
Caution: If you enter an incorrect PIN code 3 times in a row,
your SIM card is disabled and your phone displays
3 If necessary, enter your 4-digit unlock code and press
(+) to unlock the phone.
OK
At startup, you may be prompted to personalise your phone. Select
(-) to set personal phone options, or
YES
home screen. For more information about personalising your phone,
see page 85.

Turning Your Phone Off

Action
Press and hold the power key P for 2 seconds to turn the phone
off.
24 - Getting Started
2.
4.
.
SIM Blocked
(+) to go to the
NO
Tip: The angle connector provided with your phone makes it easier
for you to use the phone with an attached battery charger or phone
accessory.
Action
1 Insert the travel charger plug
into the detachable angle
connector as shown.
2 Insert the angle connector
plug into the USB connector
port on your phone.
3 Plug the other end of the travel charger into the appropriate
electrical outlet.
Note: It may take up to 10 seconds for your phone to provide
a visible or audible indication that the battery is charging.
4 When your phone indicates
charger and angle connector.
Note: You can safely leave the travel charger connected to the
phone after charging is complete. This will not damage the battery.

Adjusting Volume

Press the up or down volume keys to:
• silence an incoming call alert
• increase or decrease earpiece
volume during a call
• increase or decrease ringer
volume when the home screen is
visible (flip must be open)
Tip: At the lowest volume setting,
press the down volume key once to switch to vibrate alert.
Press it again to switch to silent alert. Press the up volume key
to switch back to vibrate alert, then ring alert.
Making a Call
You must be in the home screen to dial a phone number (see
page 36).
Press To
1 keypad keys dial the phone number
2 N make the call
3 O end the call and "hang up" the phone
when you are finished
Tip: You can also close the phone flip to end the call.
, remove the travel
Charge Complete
Getting Started - 23
040135o
Getting Started - 25