Dishware Drying; Operating The Dishwasher - Bosch Integra SHX43M02UC User Manual

OPERATING ThE dIShWAShER

To start the dishwasher, follow the instructions in Figure 28 and
29 below.
You could be seriously scalded if you allow hot water to
splash out of the dishwasher. OPEN THE DOOR CAREFULLY
during any wash or rinse cycle. Do not fully open the door
until water noises have stopped.
Canceling or Changing a Cycle
To cancel or change a cycle, open the dishwasher door far
enough to expose the control buttons then press and hold for
three seconds the two buttons labeled "Cancel/Reset" as shown
here.
FIGURE 27
Cancel / Reset
Close the door and wait until the dishwasher completes the
cycle (approximately 1 minute). Open the door and press the
ON/OFF button. You may now begin a new cycle.
Interrupting a Cycle
NOTE: Should you need to interrupt a cycle (to add or remove
an item, to add detergent, etc.), it is best to do so within the
irst 30 minutes of the cycle.
2) Turn on
2) Turn on
WARNING
1) Open the door
1) Close the door
4) The unit will
hidden Top Controls
1. Open the dishwasher door just far enough to expose the
control panel.
2. Press the On/Of button to turn the unit of.
3. Wait at least ten seconds or until the water noises stop
before opening the dishwasher door.
4. To resume the cycle, press the On/Of button and close
the dishwasher door.
Exposed Front Controls
1. Press the On/Of button to turn the unit of.
2. Wait at least ten seconds or until the water noises stop
before opening the dishwasher door.
3. To resume the cycle, close the dishwasher door and then
press the On/Of button.

Dishware Drying

At the end of the cycle the dishwasher will stop and a period
of condensation drying will follow. After drying, the cycle is
complete and depending on your model:
the "Clean" light will illuminate OR
the completion signal will sound OR
the countdown display will show "0" (select models) OR
the "Sanitized" light may appear. When the "Sanitized" light
" " appears, it means that the dishware and kitchenware
that was just washed has been sanitized according to the
requirements of the National Sanitation Foundation (NSF).
For more information on NSF certiication, go to the Wash
Cycle Information section of this manual.
FIGURE 28 - HIDDEN TOP CONTROLS
4) Close the
door to start
FIGURE 29- EXPOSED FRONT CONTROLS
then start
3) Select a cycle
Power Auto Regular Quick
Half
Scrub Wash
Load Wash Wash
Plus
3) Select a cycle
Refill
Rinse
Agent
Sanitized
13