Chapter 5: Configuration; Initial Setup Through The Cli; Required Connections - Alfa Network AWAP02O-86 User Manual

Chapter 5: Initial Configuration
The 2.4 GHz/5 GHz Wireless Access Point offers a variety of management options,
including a web-based interface, a direct connection to the Telnet,
Secure Shell (SSH), or using SNMP software.
The initial configuration steps can be made through the web browser interface or
CLI. The access point requests an IP address via DHCP by default. If no response is
received from the DHCP server, then the access point uses the default address
192.168.2.2 If this address is not compatible with your network, you can first use the
command line interface (CLI) as described below to configure a valid address.
Note: Units sold in countries outside the United States are not configured with a specific
country code. You must use the CLI to set the country code and enable wireless
operation.

Initial Setup through the CLI

Required Connections

The access point provides an telnet that enables a connection to a PC
or for monitoring and configuration.
5-1