Miele Touchtronic T 9820 Operating And Installation Instructions page 21

The laundry is not dry enough.
Possible fault
The load contained too many
dissimilar items (size and fabrics.)
The laundry is still wet. The program runs too long.
The gas supply is insufficient.
The drum light does not come on.
The light turns off automatically
(energy saving).
The bulb may be bad or burned
out.
The program runs too long or stops.
Important: To fix the following problems, open and close the dryer door.
The air supply is insufficient.
The lint filter is clogged with lint.
The exhaust hose or the
connection is clogged with lint.
The laundry was not spun
sufficiently in the washer.
The dryer is over loaded.
Metallic zippers prevent a correct
measurement of the laundry's
residual moisture.
Frequently asked questions
Solution
– Continue drying using the "Warm air"
program.
– Select a suitable program.
Check if the gas shut-off valve is closed.
Close and open the door, the light should
come on.
Change the light bulb.
See "Dryer Care".
Open a window or door to increase air flow.
Clean the lint filter.
– Check the exhaust parts (e.g. wall vent
duct, louvered wall vent, bends, etc.)
regularly for air permeability.
– Remove the lint.
Spin laundry thoroughly before drying.
Regard the maximum load size per
program.
– Open the zippers of the laundry before
drying.
If the problem persists, dry items with long
zippers using the "45 min. warm" program,
if necessary use the laundry basket.
21