Table of Contents
Advertisement
What to do if, . . . ?
. . . the drum door opens dur-
ing the drying cycle?
. . . drops of the water appear
along the upper edge of the
drum door?
. . . after cleaning the heat ex-
changer, water leaks from the
machine?
. . . the interior drum light fails
to function?
. . . you have to open the door
in the event of a power
failure?
Cause . . .
The machine has overheated.
The temperature limiter opened
the drum door and caused the
machine to turn off
automatically.
Possible reasons for
overheating:
– The lint filter in the door is
clogged.
– The vent duct is blocked.
– The vent aperture (e.g.
louvred window vent, wall
vent) is blocked.
This may not be a problem. A
dual filter system with two seals
is used to prevent lint from
becoming deposited in the heat
exchanger.
Problem solving guide
Remedy . . .
Before restarting the program,
proceed as follows:
– Release the ON/OFF button.
– Clean the affected part of the
machine.
– Turn on the machine again.
– Reselect the terminated
program.
– Press the "Start" button.
If the drum door opens again,
the Miele Service Dept. should
be contacted.
These two seals may
occasionally cause condensed
water to form on the door.
Laundry coming into contact
with these drops of water will
dry within in a few minutes.
Check that the heat exchanger
door has been replaced
correctly. If necessary, remove
and replace it.
See next page.
See next page.
19
Advertisement
Table of Contents
