Sony SA-NS300 Quick Setup

Sony Wireless Network Speakers
®
Easy to set up. Easy to use.
PC or Mac, play music anywhere
your Wi-Fi goes —even outside.
®
STEP 1: Introduce your speaker to your router.
Before you begin, make sure your
OPTION 1: Automatic Wired Set-up
1. Turn speaker on:
SA-NS300, SA-NS400
On back near base.
SA-NS500 ( 2 buttons )
On bottom.
Both buttons need to
be in the up position
for sync only.
OPTION 2: "WPS" Push-button Set-up
1. Turn speaker on:
SA-NS300, SA-NS400
On back near base.
SA-NS500 ( 2 buttons )
On bottom.
Both buttons need to
be in the up position
for sync only.
IMPORTANT NS500 ONLY: After connection is made, switch bottom button
Additional set-up methods for any router, computer and most operating systems are detailed in the
operating instructions manual in the box. Also enclosed is a Quick-Start Guide for PC and Mac.
router and computer are on
( easy 2-step method )
2. Connect speaker and computer to router.
When "LINK" light on speaker turns orange, unplug the
cable. System will reboot/sync to Wi-Fi
( Wi-Fi
2. Press "WPS" button
on router:
Router/Access Point
The WPS button may vary.
Check your router manual.
When "LINK" light on speaker turns orange,
system will reboot/sync to Wi-Fi
down to NETWORK STANDBY MODE to play.
SA-NS300
and connected.
Ethernet Router/
Cable Access Point
( included )
Protected 3-step method )
®
3. Press/hold "WPS"
SA-NS400 SA-NS500
To
Computer
( green light ) .
®
button ( for 3 sec. )
on back of speaker
( green light ) .
®