Configure Wan Connection (Adsl Service Connection) - D-Link DSL-500G User Manual

Configure WAN Connection (ADSL Service Connection)

Click on the Quick Configuration hyperlink to access the configuration settings you need to establish the ADSL
connection.
When setting up the Router for the first time, use the Quick Configuration window and follow the steps below to
change settings as instructed by your ISP. Some of the settings can be left at their default value depending on the
requirements of the connection. Details about the settings listed here can be found in the next chapter.
1. PVC: Leave this set at the default value 0 the first time the Router is set up. For more information on
this option see Multiple PVC Operation
2. Operation Mode: This also should be left at the default setting Enabled. This enables the PVC used for
the initial connection.
3. Connection Type: Change connection method and packet encapsulation technique as instructed by your
ISP. The available connection types are PPPoE LLC, PPPoE VC-Mux, PPPoA LLC, PPPoA VC-Mux,
IPoA LLC, IPoA VC-Mux, Bridged IP LLC, Bridged IP VC-Mux, form the pull-down menu. Default
Connection Type = PPPoE LLC.
4. VPI: If instructed to change this, type in the VPI value for the initial connection (using PVC 0). Default
= 0.
5. VCI: If instructed to change this, type in the VCI value for the initial connection (using PVC 0). Default
= 35.
6. Bridge: This may be left t the default setting Disabled. Some users may opt to enable this now by
selecting Enabled from the drop-down menu.
7. IGMP: Leave this set to Disabled.
8. IP Address: & Subnet Mask: Some users may be required to configure the IP settings for the WAN
connection. If you are using IPoA or a Bridged IP connection, you may be instructed by your ISP to
enter your global IP settings. If you are told to enter an IP Address and Subnet Mask, enter ithem here.
DSL-500G ADSL Router User's Guide
Quick Configuration Window
14