Table of Contents
Advertisement
Port redirection is universally enabled or disabled for the Router with the Port Redirection State drop-down
menu. The Existing Entry number tells you how many sets currently are configured. The Valid Entry number
tells you the number of sets that are active.
Select index to set
State
Protocol
Internet
Start Port
End Port
Local IP Address
If you wish to delete or modify an existing rule, select the index number and click the action button for Delete or
Modify. Clicking on the Clear button will set the variables to the blank or default setting.
Each new set that is added will appear in the entry table at the top of the web page. When you have configure all
the redirection sets you want to produce, click on the Apply button. You can save and reboot the system now, or
continue to configure the Router.
DSL-1500G SHDSL Ethernet Router User's Guide
When adding a new set, choose the Not selected option from the drop-
down menu first. This will automatically add the next available index
number to the new rule. If you are deleting or modifying an existing rule,
select it and click the appropriate button to the right.
Select Enabled to put the set into effect when it is applied. To save a set
you do not want to use now for later use without deleting it you can
choose Disabled.
Select the designated TCP or UDP protocol port number or use a well-
know port for the particular protocol packet you wish to redirect.
Select one of the well-known ports to redirect incoming packets through
that port.
For a range of ports, this will be the first port in the range. For a single
port enter the port number.
For a range of ports, this will be the last port in the range. For a single
port just enter the same port number entered in Start Port.
Enter the IP address of the local designated host computer or device.
29
Advertisement
Table of Contents
