Display Board; Power Failure Resume Function; Sleep Operation; Operation Mode - Haier HSU-18H03/R - annexe 1 Operation Manual

Operation

Display board

Operation
Before going to bed, you can simply press the
SLEEP button and unit will operate in SLEEP
mode and bring you a sound sleep.
Use of SLEEP function
After the unit starts, set the operation status,
then press SLEEP button before which the
clock must be adjusted and time being set.

Operation Mode

1. In COOL,DRY mode
1 hours after SLEEP mode starts, temp. will
become 1 C higher than temp. setting. After
O
another 1 hours, temp. rises by 1
The unit will run for further 6 hours then stops.
Temp. is higher than temp. setting so that room
temperature won't be too Iow for your sleep.
Remote Controller
PURIFY
FRESH
C further.
O
POWER/SOFT

Sleep Operation

SLEEP operation starts
1 hr
Rises 1
1 hr
Temp.setting
In COOL, DRY mode
2. In HEAT mode
1 hours after SLEEP mode starts, temp will become
2 C lower than temp. setting. After another 1 hours,
O
tempdecrease by 2
hours, temp. rises by 1
for further 3 hours then stops. Temp. is lower than
temp. setting so that room temperature won't be too
high for your sleep.
Temp.setting
1 hr Decreases 2
1 hr
Decreases 2
3 hrs
SLEEP
operation starts
In HEAT mode
3. In AUTO mode
The unit operates in corresponding sleep mode
adapted to the automatically selected operation mode.
4. In FAN mode
It has no SLEEP function.
5.
When TIMER function is set, the sleeping function
can't be set up .After the sleeping function is set up,
if user resets TIMER function, the sleeping function
will be cancelled; the machine will be in the state of
timing-on.
6.Note to the power failure resume:
press the sleep button ten times in five seconds
and enter this function after hearing four sounds.
And press the sleep button ten times within five
seconds and leave this function after hearing
two sounds.

Power Failure Resume Function

If the unit is started for the first time, the compressor will
not start running unless 3 minutes have elapsed.When
the power resumes after power failure, the unit will run
automatically, and 3 minutes later the compressor starts
running
NOTE: With the power failure resume, if setting the TIMER ON,
TIMER OFF and TIMER ON/OFF,the unit is off when
resuming after power out.
15
SLEEP operation stops
Approx.6hrs
Rises 1 O C
C
O
Unit stop
C further. After more another 3
O
C further. The unit will run
O
Unit stop
C
O
C
O
3 hrs
Rises 1 C
O
SLEEP
operation stops