D-Link DSL-360T User Manual page 34

1. Type in a Name in the space provided.
2. Select CLIP under Type.
3. Under Options, enable NAT and/or Firewall by selecting the appropriate checkbox. This option is not
available for a Bridge connection.
4. Based upon the information your ISP provided, enter the IP Address (e.g. 168.128.1.1), the Subnet Mask
(e.g. 255.255.255.0), ARP Server (e.g. 168.128.1.2) and the Default Gateway (e.g. 168.128.1.1).
5. Do not change the VPI or VCI values unless you are required to do so. If these settings are incorrect, the
ADSL connection will not function. Many users will be able to use the default settings. If you are told to
change these, type in the values given to you by your service provider.
6. Leave the default QoS values if you are unsure or the ISP did not provide this information.
7. Do not change the PCR or SCR values unless you are required to do so. If you are told to change these, type
in the values given to you by your service provider.
8. Click the Apply button when you have entered all the information. The web browser will briefly go blank.
After a few seconds the new connection you just configured will be listed in the left panel of the Setup
window as "Connection 1," "Connection 2," "Connection 3," etc.).
9. To make your temporarily saved connection permanent, click the Save All button in the System
Commands window on the Tools tab.
DSL-360T ADSL Modem User's Guide
24