Beko WM 5100 S Installation & Operating Instructions And Washing Guidance page 31

You may not be using
proper detergent for
automatic washing
machines.
Excessive amount of
detergent may have been
used.
Too much detergent
may have been used for
a small amount of lightly
soiled laundry.
Detergent may have been
stored improperly.
There is too
Type of material being
much foam.
washed (lace items will
cause excessive foam due
to their meshed structure).
Detergent might have
been put in the wrong
compartment.
Softener being released
early.
The plug might not be
plugged in the mains
outlet.
Machine does
Fuse may have blown.
work. No light
is on.
Electricity may be cut off.
The "On/Off" button might
have not been pressed.
The machine
did not start
after the
program was
The front door may be
selected and
ajar.
the 'Start/
Pause/Cancel'
button was
pressed.
"Washing"
and "Start/
Pause/Cancel"
Water may have been cut
lights are
off.
flashing after
the program is
started.
It shows the safety period
The "Lid" light
until the door lock is
is flashing.
opened.
Use only automatic washing machine
detergents in your washing machine.
Use only sufficient amount of detergent.
Use only sufficient amount of detergent.
Store detergent in a closed and dry location. Do
not store in excessively hot places.
Use smaller amounts of detergent for lace
items.
If you put detergent in the prewash
compartment although you have not selected
a prewash cycle, the machine can take this
detergent during rinsing or softener step.
You may have added too much softener.
The detergent dispenser might be problematic.
Water may be siphoned (pulling the softener
into the washer early) during the fill or rinse
cycles.
There might be problems with the valves.
Plug should be checked.
Fuse should be checked.
Power should be checked.
This button must be pressed.
You can restart your machine by pressing the
"Start/Pause/Cancel" button for a short time
after ensuring that the water is not cut off.
For your safety, the front door can only
be opened 2 minutes after the program is
completed. The "Lid" light will flash during this
period.
31
EN